Motor Limiting Table - Phoenix Mecano RK ROSE+KRIEGER DuoLine S Notice D'assemblage

7. Life Phases 7. Life Phases 7. Life Phases

7.2.5 Motor limiting table

Version
RK DuoLine S 50 × 50
RK DuoLine Z 50 × 50
RK DuoLine Z 80 × 80
RK DuoLine S 80 × 80
RK DuoLine Z 80 × 160
RK DuoLine Z 120 × 80
RK DuoLine S 120 × 80
RK DuoLine Z 120 × 80 II
RK DuoLine S 60
RK DuoLine S 80
RK DuoLine Z 60
RK DuoLine Z 80
RK DuoLine Z 120
RK DuoLine Z 120 II
RK DuoLine Z 160
* Distance from the mounting surface of the motor adapter to the mass centre of gravity
Transfer units RK DuoLine Z 80 x 80, 80 x 160, 120 x 80, 120 x 80 II
Linear units arranged in parallel must be matched to the transfer shaft to transfer torques. This
can - just as with the motor - be fixed to the steering with couplings, depending on the version.
If the designed installation length is greater than the maximum installation length or maximum
speed determined from the "estimated shaft design" formula, then a stationary bearing support
is used to absorb the corresponding loads.
Estimated shaft design:
max. installation length [mm] = (2720 - speed [min-1]) + 2 x 107.5
max. speed [min-1] = 2720 - L [mm]
The interface combinations determined by RK Rose+Krieger GmbH from coupling and transfer
unit are binding.
without protection
Version
Standard or synchronous
Deflection
70 70 70
Max. motor weight in kg
8
8
8
16
16
16
16
8
16
8
8
16
40
with protection
Stationary bea-
ring support
Deflection
Centre* of gravity distance
in mm
Standard design
Clamping hub
Synchronous design
Clamping hub
280
300
400
400
400
400
400
300
400
300
400
400
400
Clamping hub
Clamping ring hub