System Info; System Update - MAHLE ACX150 Manuel D'utilisation

4. Before opening the doors of
the equipment, switch off
the equipment
disconnect
supply cord.
DANGEROUS VOLTAGE HAZARD
5. Remove the six screws that
fix the front door of the unit.
6. Unscrew the 2 connection
nuts of the filter by means of
the hex keys.
7. Remove
wind up the filter
DRYER FILTER
8. Install the new filter paying
attention to the position of
gaskets and to the direction
of the arrow indicating the
fluid flowing direction.
9. Screw the two connection
nuts of the filter.
10. Replace the front panel
11. Carry out the automatic leak
test requested
software when switched on
again after
replacement.
and
the power
the straps that
NUTS
by the
the filter
EN | 30 | ACX150/250 | Maintenance

14.10 System info

In the main menu select MAINTENANCE
and press "INFO".
In the INFO page, at any time, the
software version and the serial number
can be displayed.

14.11 System update

The firmware
updated by way of a USB stick.(where
the new version is stored).
1. Insert the USB stick in
USB port (fig.3 pos.4)
2. Power on ACX150/250.
3. In the main menu select
MAINTENANCE
press
UPDATE".
4. A message will appear
that the unit is loading
an update.
5. The unit may load an
updated language file,
database
configuration file while
updating.
6. Once unit is updated,
the
string
introduction
during
change.
(software) can
"SYSTEM
file
software version
on
screen
power up
© MAHLE
be
and
and
the
will