Pump Oil Replacement; Oil Pump Visual Check; Dryer Filter Replacement - MAHLE ACX150 Manuel D'utilisation

EN | 29 | ACX150/250 | Maintenance
Upper filling plug
Oil inspection
window
Lower
drain plug
4. Once
emptied, screw the lower plug
again.
5. Fill the pump with new oil
through the upper opening,
using a funnel if needed. Bring
new oil level halfway through
the oil inspection window.
6. Once the pump has been filled,
close the upper plug.
7. Once oil has been replaced,
switch on the unit and from the
MAINTENANCE
PUMP
press the "RESET" key to set
the counter.

14.8.1 Oil pump visual check

Without opening the equipment is always
possible to remove the rubber tap in the
following position to check level and the
clearness of the oil inside the pump.
© MAHLE
the pump has
menu
OIL REPLACEMENT:
14.9 Dryer filter
The dehydrator filter must be replaced
after having dehydrated 150 kg of
refrigerant fluid, since the filter capacity to
keep
refrigerant will run out.
To replace the dryer filter, from the
MAINTENANCE
FILTER REPLACEMENT: press "START"
to set the counter to zero and to start the
filter replacement procedure. Insert the
code of the new filter. Now you can
been
replace the filter.
Required tools:



For replacement,
instructions outlined below:
select
DANGER OF CONTACT WITH R134a
REFRIGERANT and motor vehicle A/C
replacement
the humidity present
menu
1 Hex screwdriver (2.5 mm)
1 regular or torque Hex key (24
mm)
1 Hex key (17 mm)
comply
1. disconnect the HP and LP
hoses from
systems/circuits or vehicles
and close
couplers
2. wait the ends the hoses
emptying.
3. confirm to
worn the personal protective
equipment (PPE) and follow
the safety regulations in
force.
system oil
in the
select DRYER
with the
other
the quick
have already