Positioning And Connection; Initial Verification - MAHLE ACX150 Manuel D'utilisation

EN | 17 | ACX150/250 | Commissioning
8.1.1

Positioning and connection

HANDLING: During handling, the
minimum devices required for
correct handling shall be ensured,
as provided
prevention provisions.
POSITIONING: Place the unit in a
stable place. The location must be
well ventilated, with a good rate of
change of air. The unit must be
located at least 10 cm from any
potential obstacles to its internal
ventilation. Keep the unit away
from rain and excessive humidity
as they can irreparably damage it.
In addition, the equipment must
never be directly exposed to the
sunrays or to excessive dust.
INSTALLATION: the unit must be
installed
technician
observance of in accordance with
electrical engineering principles.
The use of the equipment in
explosive
forbidden.
CONNECTIONS: since the unit is
connected to the main power
supply,
grounded with its power plug
GND pin. Failure to ground the
unit can
constitutes a risk of fatal injury to
the operator. Position the unit so
that the power plug is easy for the
operator to access.
© MAHLE
for by accident
by a specialised
in scrupulous
atmosphere
it must be properly
damage it
Power mains
connection
ATTENTION: Leave the quick
coupling taps closed when the
unit is not in use and at the end of
vehicle service operations.
8.2

Initial verification

Execute the following actions in sequence
by following the display guided procedure
and the illustrations on the screen of the
equipment:
is



It is possible to interrupt the initial check
and print a report with the equipment
printer in which the checking status is
reported. The equipment cannot operate
and
in automatic mode until all the steps of
the initial check have been completed.
CAREFULLY ABIDE BY
REFRIGERANT IN THE
Vehicle A/C system
connections
Refrigerant weight check
Oil weight check
First tank filling
THE FOLLOWING
INSTRUCTIONS TO
AVOID DANGER TO
PERSONS, THE
DISCHARGE OF
ATMOSPHERE