Uv Dye Bottle Filling; Setup; Electric Compressor Function; Charge Mode - MAHLE ACX150 Manuel D'utilisation

EN | 19 | ACX150/250 | Setup
8.4

UV dye bottle filling

The UV Dye is a substance made up of a
yellow-green
pigment, which means that, when lit by
an ultraviolet
fluorescent and thus visible.
The UV dye can therefore be used to
detect leaks of a small entity inside the
auto vehicle A/C system.
To fill the UV dye bottle (Fig.1 Pos. 6) it
has to be extracted from its housing by
means of the quick coupler on the top of
the bottle; slightly press downward the
coupler ring nut to extract it.
Fill the bottle by paying special attention
to the "oil care" valve.
This valve is made of a silicon polymer
membrane; it
variations within the bottle
humid air infeed inside thus preserving
the new oil inside.
After filling, close the bottle and place it
back in its seat.

9 Setup

From the SETUP menu it is possible to
select parameters and activations before
starting cycle:
© MAHLE
coloured fluorescent
lamp, it becomes
compensates pressure
and stops

ELECTRIC COMPRESSOR FUNCTION


by selecting this entry, one may
change the type of Oil to inject into
the A/C system.
E³ CONNECT

by selecting this entry, you can
enable the E³ CONNECT
(the E³ CONNECT
must be present on the car).

CHARGE MODE


by selecting this entry, one may
decide whether to enable use of the
Quick Mode
charge method
AC PERFORMANCE TEST

by selecting this entry, one can
enable or
PERFORMANCE TEST.
REFRIGERANT CLEAN

by selecting this entry, one may
decide whether or not to enable the
refrigerant clean
enables an
within the station itself, started in
automatic when it is switched on but
not in use. This function ensures a
higher level of purity of the recycled
refrigerant to the advantage of the
service quality.
RECOVERED GAS AND OIL PRINTING

selecting this entry, you can choose
whether you
displaying and
recovered gas
available only with printer installed.
REPORTS SAVING MODE

by selecting this entry, you can save
the reports of the performed charges
(automatic cycle or Reg. 842/2006).
function
quick coupler
or Zero Tolerance
disable the
function, which
additional recycling,
want to enable
printing of
quantity. Setting
AC
the