auna Stereo Sonic DAB+ Mode D'emploi page 46

EN
46
2. Signal Bar
Transmission signal level. The more the star mark is displayed, the
stronger the signal is received. To improve the reception adjust the wire
antenna position.
3. Program Type (PTY)
Type of program provided by the broadcaster.
4. Multiplex Name
Displays name of multiplex to which the current station belongs.
5. Frequency'
Current channel frequency.
6. Signal Error Rate
Shows the error rate. The larger this value, the more errors it receives. To
improve the reception, adjust the antenna position.
7. Audio Bit Rate
This is the current channel audio Bitrate.
8. Time
Displays the time provided by the radio station.
9. Date
Displays the current date provided by the radio station.
Other DAB menu operations
Press the MENU button to access the menu control. Then press the
PREVIOUS or NEXT button for different options as described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy
environment. The DRC level of a broadcast is set by the broadcaster and
transmitted with the service. Changing the DRC value on your unit enables
you to apply a scaling factor to this level.
There are three levels of compression:
DRC high: Maximum compression as sent with the transmitted service
DRC low: Set to 1/2 that of the sent transmitted service
DRC off: No compression
1. Press the MENU button to access the menu control.
2. Press the PREVIOUS or NEXT button until "DRC" is displayed and then
press the ENTER button.
3. Press the PREVIOUS or NEXT button to select the DRC value and then
press the ENTER to confirm.
4. Press the MENU button to exit the menu control.
Note:
• Not all DAB broadcasts are able to use DRC function. If the broadcast
does not support DRC then the
• DRC setting in the unit will have no effect.
• After you have adjusted the DRC level the sound may be louder.