Common Operations; Turning Power On/Off; Switching Display Modes (Input) - Sharp LL-171ME Mode D'emploi

Turning power on/off

INPUT
MENU
BRIGHT
/
OK
MODE
CH
/BRIGHT
MAIN
POWER
Turning power on
When the power LED is off:
1. Press the MAIN POWER button on the monitor.
2. Turn on power for the connected equipment.
After a while the power LED will light green, and
then the display mode will be displayed for
several seconds.
When the power LED is lit red (standby):
1. Press the POWER button on the remote control.
2. Turn on power for the connected equipment.
The power LED will light green, and then the
display mode will be displayed for several
seconds.
Turning off power
1. Turn off power for the connected equipment.
2. Press the POWER button on the remote control.
The power LED will light red (standby).
3. Press the MAIN POWER button on the monitor.
The power LED will go out.
Notes:
- Always wait at least 5 seconds between
switching power off/on. Rapid switching may
damage the monitor or cause it to malfunction.
- After switching power on, it may take a little
while before the screen displays an image.
- Do not turn off the power immediately after
changing various settings on the screen. The
changed values may not have been saved in the
memory yet.

Common operations

Switching display modes (INPUT)

[Monitor]
1. Press the INPUT button.
POWER
VIEW MODE
PIP
PC TV AV1 AV2
SUBPAGE REVEAL SUBTITLE TEXT
SLEEP MENU
OK
BRIGHT
BRIGHT
MODE
FREEZE
DISPLAY SOUND
/HOLD
CH
[Remote control]
1. Press the PC, TV, AV1, or AV2 button.
Notes:
- When you turn on the monitor, the initial display
- Using the
E18
Each time you press the button, the input
changes in the following order:
PC → Number (TV) → AV1 → AV2 → PC...
Display modes
PC PC mode Displays the computer's
image.
Number TV mode Displays the TV's image.
The number will be the
channel being received.
AV1 AV1 mode Displays the image from
the equipment connected
to the AV1 input.
AV2 AV2 mode Displays the image from
the equipment connected
to the AV2 input.
The monitor will switch to the display mode for
the button you pressed.
mode will be the mode being used when the
monitor was last turned off.
buttons or channel buttons on the
remote control (0-9), or selecting channels using
the programme table also automatically switches
to TV mode, except for the following cases when
in PC mode.
- When you are watching TV in the PIP window
(see page E20).
- When you are listening to TV (see page E21).
In these cases, switch the display mode to TV
using the INPUT button (monitor) or the TV
button (remote control).
P C