Turning Power On/Off; Turning On The Main Power; Disabling Power On/Off Operations - Sharp PN-G655U Mode D'emploi

Caution
• Turn on the monitor first before turning on the PC or
playback device.

Turning on the main power

When the main power switch is off, the monitor cannot be
turned on using the POWER button on the remote control unit.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
Status of a power LED
Green lighting
Orange lighting
Green flashing
Caution
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
14
E
Turning Power On/Off
Main power switch
INPUT
Power LED
Status of the monitor
Power "On"
Power "Off" (Standby mode)
Input signal standby mode
(input using a PC)
TIPS
• If the monitor is in the input signal standby mode and you
press the POWER button on the remote control unit, the
monitor enters standby mode.
• You can turn on/off the monitor by pressing the power
switch of the monitor.
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby mode.
Date/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/
SET 20 07
CANCEL
1. Press , ,
time, and press or
values.
2. Select SET and then press
• Be sure to set the date and time.
• The date/time setting screen will close automatically if no
operation is performed for about 15 seconds. The date
and time can be set using DATE/TIME SETTING from
the OPTION menu when the date/time setting screen
disappears.
TIPS
Set the date in "Year/Month/Day" order.
•
Set the time on a 24-hour basis.
•
The clock stops after the power-off status continues for
•
approximately 1 week.* The date/time setting screen
appears at power-on. Be sure to set the date and time.
(
* This is a guide. The power-off status that stops the clock
depends on the status of the monitor.)

Disabling power on/off operations

Power on/power off operations can be disabled in order to
protect the monitor from an accidental power off. Set the
ADJUSTMENT LOCK in FUNCTION menu to "2". (See page
24.)
/ : :
/ 01 / 01 00 : 00
OK···[MENU]
or to select the date and
to change the numerical
.
MENU