Using Walking Foot; Using 1/4Ý Seam Foot - Janome Pink Ribbon MS5027 Manuel D'instructions

Janome MS5027 Instruction Manual

Using Walking Foot

Thumb screw
1
2 Foot holder
3 Lever
4 Needle clamp
5 Presser bar
This is a special attachment for hard-to-feed materials.
This foot prevents fabric slipping or puckering by feeding
fabrics with both upper and lower feed dogs. The walking
foot is great for fine fabrics, knits, leather and matching
plaids.
Turn off the switch
1
Raise the needle and presser foot.
2
Loosen the thumbscrew and remove the foot holder
3
(Refer to page 12)
Attach walking foot to the presser bar with the lever
4
above the needle clamp, and secure it with the thumb
screw.
NOTE:
Sew at low to medium speed.
Set the stitch length in the range of 0-4.
Using 1/4ý Seam Foot
Stitch selector:
1
2 Stitch width:
3 Stitch length:
4 Needle thread tension:
Presser foot:
5
NOTES:
When using the 1/4ý seam foot, make sure to use the
center needle position, otherwise the needle may strike
the presser foot and possibly break.
Use a #11 blue stretch needle, which effectively prevents
skipped stitching.
Using the black bar as a guide, straight stitch fabric pieces
together. Use for keeping layers of fabric feeding evenly.
This foot is a must for sewing lightweight fabrics, matching
plaids, stripes and quilting.
www.toews.com
7
6.5
Red zone
3 to 5
1/4ý seam foot
1
3
1
4
1
4
5
4
3
44
Janome Pink Ribbon
2
1
2
3
4
5
2
3
5
MS5027 Owners Manual/ User Guide