Removing The Hook Cover Plate; Inserting The Bobbin - Janome Pink Ribbon MS5027 Manuel D'instructions

Janome MS5027 Instruction Manual

• Removing the hook cover plate

Hook cover plate release button
1
2 Hook cover plate
Slide the hook cover plate release button
and remove the cover plate

• Inserting the bobbin

End of thread
1
Notch
2
3 Notch
4 Threading diagram
Place a bobbin in the bobbin holder with the thread
1
running off counterclockwise.
2 Guide the thread into notch
the bobbin holder. Draw the thread to the left, sliding it
between the tension spring blades.
Continue to draw the thread lightly until the thread slips
3
into notch . Pull out about 6" (15.0 cm) of thread.
3
Attach the hook cover plate. Check the threading by
4
referring to the diagram
www.toews.com
to the right,
1
.
2
on the front side of
2
shown on the hook cover plate.
4
1
1
2
3
3
4
26
Janome Pink Ribbon
1
2
2
1/8 3/8 5/8
10
4
MS5027 Owners Manual/ User Guide