Table des Matières
Publicité
Janome MS5027 Instruction Manual
• Drawing up bobbin thread
Raise the presser foot. Hold the needle thread lightly
1
with your left hand and rotate the handwheel
counterclockwise for one complete turn.
Bring the bobbin thread up by pulling the needle thread
2
up.
3
Pull both threads 4" to 6" (10.0 to 15.0 cm) under and
behind the presser foot.
Adjust the Needle Thread Tension for a Straight
Stitch
• Correct tension
Needle thread (Top thread)
1
2
Bobbin thread (Bottom thread)
To loosen
3
To tighten
4
The ideal straight stitch has threads locked between two
layers of fabric, as illustrated (magnified to show detail).
If you look at the top and bottom of a seam, notice that
the stitches are evenly balanced.
When adjusting the needle thread tension, the higher the
number, the tighter the top thread tension.
Results depend on:
- stiffness and thickness of the fabric
- number of fabric layers
- type of stitch
•Tension is too tight
Needle thread (Top thread)
1
Bobbin thread (Bottom thread)
2
3
To loosen tension
Right side (Top side) of fabric
4
Wrong side (Bottom side) of fabric
5
The bobbin thread shows through on the wrong side of the
fabric, and the stitch feels bumpy. Turn the dial to a lower
tension setting number to loosen the needle thread tension.
www.toews.com
1
2
3
3
4
4
1
2
3
30
Janome Pink Ribbon
1
2
4
5
4
MS5027 Owners Manual/ User Guide
Publicité
Table des Matières
