Specifications; Electrical Characteristics - Chauvin Arnoux E3N Mode D'emploi

www.allice.de

4.1. ELECTRICAL CHARACTERISTICS

Range
100mV/A range
10mV/A range
10mV/A range
10
0
0
-5
-10
-15
-20
Typical noise level on output (peak-to-peak value)
Frequency band
10mV/A range
100mV/A range
„ These data assume an ambient temperature of 23±3°C, a relative humidity of 20 to 75%, a frequency
from DC to 1kHz, a load impedance of 1MW/100pF, and a conductor that is centred and parallel
to the mark.
„ Pass band: DC to 100kHz.
„ The pass band of the associated oscilloscope depends on the frequency of the signal to be measured.
A pass band greater than four times the frequency of the signal to be measured is sufficient.
„ Frequency of use (not entailing an additional error of more than 3% with respect to the reference
Allice Messtechnik GmbH

4. SPECIFICATIONS

Measurement range
50mA to 10A peak
50mA to 40A peak
40A to 100A peak
Linearity for a DC signal (10mV/A range)
20 30 40 50
DC - 100kHz
480µV
3mV
Intrinsic uncertainty
See curve below
60 70 80 90
18
3% +50mA
4% +50mA
I (A)
100