Technical Information; Installation Considerations - Hansgrohe AXOR Montreux 16570 1 Série Instructions De Montage / Mode D'emploi / Garantie

Tools Required / Outiles Utiles /
Herramientas Útiles
¼"
This unit meets or exceeds the following:
• ASME A112.18.1
• CSA B125.1
• Listed by IAPMO for use in the US
and Canada
2
English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

12 mm
• For best results, Hansgrohe recommends that
• Please read over these instructions thoroughly be-
• The finished wall surface must be complete and
• The screws and anchors included are suitable for
• If the showerpipe is to be installed in a fiberglass
• Protection against backflow is provided by check
• To prevent scald injury, the maximum output tem-
• This thermostatic mixing valve is for use with a
• Keep this booklet and the receipt (or other proof
this unit be installed by a licensed, professional
plumber.
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
sealed before installation of the showerpipe.
installation on solid surfaces such as tile, dense
natural stone, etc. The wall should be flat, with-
out protruding tiles, joints, etc.
or acrylic shower enclosure, the wall must be
reinforced.
valves.
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112°F.
showerhead rated at 9.5 L/min (2.5 GPM) or
higher.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.5 GPM
2.5 GPM