Technical Information; Installation Considerations - Hansgrohe Raindance Select S 240 2jet Showerpipe 271291 Serie Instructions De Montage / Mode D'emploi / Garantie

English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• This showerpipe is for use with shower heads rated
at 2.5 GPM (9.5 l/min) or higher.
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Make sure that the wall is strong enough to support
the showerpipe. Hansgrohe strongly suggests
installation of a header at the top mounting point.
• The area where the top mounting piece is to be
installed must be flat and free of protruding grout
joints, etc.
This unit meets or exceeds the following:
• ASME A112.18.1/ CSA B125.1
• Listed by IAPMO for use in the US
and Canada
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.5 GPM max.
2.5 GPM max.
• The enclosed screws and anchors are suitable for
• This showerpipe requires showerpipe rough
• To prevent scald injury, the maximum output
• Keep this booklet and the receipt (or other proof
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
16181181(not included).
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.