How To Pause A Treatment Session; Finishing A Treatment Session; Removing The Shorts - Atlantic Therapeutics Innovo Mode D'emploi

7.3 HOW TO PAUSE A TREATMENT SESSION

If you wish to pause a session before it is finished, simply press the On/Off
button ( ) briefly. The stimulation will stop and the display will indicate that the
controller is paused (Fig. 29). To resume the session, briefly press the On/Off
button again. The display will return to the timer countdown and the stimulation
will begin again. However, if the session is paused for 2 minutes or more, the
intensity will be halved when the session is resumed. This is a safety feature to
ensure that the intensity you had previously reached is not excessive once you
have become unaccustomed to the sensation.
You may switch off your controller at any time during a session by pressing the
On/Off button for two seconds. The controller will power off and your session will
terminate.

7.4 FINISHING A TREATMENT SESSION

1. The treatment session is completed when the counter reaches zero. The
display will flash "00:00" (Fig. 30), stimulation is reduced to zero and the
controller will beep to indicate the end of the session.
2. Once the session is complete, switch the controller off by pressing the On/
Off button ( ) for two seconds.
3. Disconnect the leads from the controller and the shorts (Fig. 31).
4. If you are using the neck strap, you can remove the controller from around
your neck.
Note: If you do not switch the controller off, it will do so automatically after 10
seconds. However, if another button is pressed within this 10-second period,
the controller will remain on for 2 minutes, at which point it will switch off
automatically.

7.5 REMOVING THE SHORTS

1. Remove the shorts by pulling the waistband down. The shorts will be inside
out once removed.
2. Fold the Shorts in half to ensure that the electrodes
remain flat when packed away.
16
tton ( )
paused
e display will
ion
isplay will
will beep to
tton
.
Fig. 33
Fig. 33
Fig. 29
Fig. 30
Fig. 31
Fig. 32