Standard Accessories; Applications - HIKOKI BL36200 (SA) Mode D'emploi

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed on page 156.
Standard accessories are subject to change without
notice.
SPECIFICATIONS
Model
Battery capacity
Output voltage
Adapter output
Maximum output current
Output voltage
USB output terminal
Maximum output current
Operating temperature range
Adapter cable length
Large-capacity power dimensions
Included adapter type (page 156)
Large-capacity power
Weight Power adapter
Carrier
NOTE
Due to HiKOKI's continuing program of research and development, the specifi cations herein are subject to change
without prior notice.
CHARGING
Charge the back pack power supply before using as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red. (At 1-second
intervals)
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. lnsert the adapter of back pack power supply into
the charger.
Place the back pack power supply in a horizontal
position and turn it on by the switch on the side. Firmly
insert the battery into the charger.
NOTE
If the charge indicator lamp of the charger blinks in red
(high temperature standby status) when the adapter is
inserted into the charger, check that the battery status
lamp on the back pack power supply control panel is lit
in red.
If the battery status lamp is OFF, the back pack power
supply switch may be turned OFF.
If the back pack power supply switch is turned OFF,
disconnect the adapter and turn on the switch before
reinserting the adapter.
3. Charging
When inserting an adapter of back pack power supply
in the charger, the charge indicator lamp will light up
continuously in blue.
When the back pack power supply becomes fully
recharged, the charge indicator lamp will light up
continuously in green. (See Table 2)

APPLICATIONS

○ Power Supply for HiKOKI Cordless Power Tools
• BL36200 (SA) : models CG36DA/CG36DTA,
CH3656DA, CS3630DA, RB36DA,
CG36DL/CG36DAL, CH36DL,
CS36DL, RB36DL
• BL36200 (S) : models CG36DL/CG36DAL, CH36DL,
CS36DL, RB36DL
○ Power Supply for USB-Connection Equipment (DC 5 V)
Table 1
BL36200 (SA)
Li-ion DC 36 V 21 Ah (21000 mAh) 80 cells
330 mm × 250 mm × 109 mm
Ⓐ, Ⓑ
● Charge indicator lamp indication
The indications of the charge indicator lamp will be
as shown in Table 2, according to the condition of the
charger or the back pack power supply.
5
English
BL36200 (S)
DC 36 V
50 A
DC 5 V
0.5 A
0°C – 40°C
1.5 m
Ⓑ
6.3 kg
0.5 kg
1.0 kg