Standard Accessories - HIKOKI NT 65MA4 Mode D'emploi

SPECIFICATIONS
Type of power
Air pressure (Gauge)
Applicable nails
Numbers of loadable nails
Size
Weight
Nail-feeding method
Hose (inside dia.)
NAIL SELECTION
Only nails shown in the Table below can be driven with this Nailer.
15 Gauge finish nails

STANDARD ACCESSORIES

(1) Case ............................................................................. 1
(2) Eye protector .............................................................. 1
(3) Nose cap (mounted on tool) ...................................... 1
APPLICATIONS
Manufactured Housing, On-site and Mobile Home
Construction.
Cabinets, Furniture, and Woodworking.
Piston reciprocating
4.9 – 8.3 bar (70 – 120 psi.)
ref. Fig.
100 nails (1 strip)
344 mm (L) × 304 mm (H) × 82 mm (W) (13-1/2" × 12" × 3-1/4")
1.9 kg (4.2 lbs)
Spiral spring type
6 mm (1/4")
Dimensions of nails
Min.
2.4mm (.095")
1.8mm (.072")
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum
6 mm (1/4") inside diameter.
NOTE
The air supply hoses must have a minimum working
pressure rating of 10.4 bar (150 psi.) or 150 percent of
the maximum pressure produced in the air supply
system, whichever is higher.
2. Check on safety
CAUTION
Unauthorized persons (including children) must be
kept away from the equipment.
Wear eye protector.
Check the retaining screws which fix the exhaust
cover, etc. for tightness.
Check the nailer for air leaks and defective or rusty
parts.
Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
Recheck on operational safety.
English
Max.
8