Setting A Schedule - Mitsubishi Electric RedLINK MHK2 Manuel D'utilisation

Commercial Program Default Settings
This Remote Controller is pre-set to use energy saving program settings. We recommend
these settings, since they can reduce your heating/cooling expenses.
See table below with the default 5+2 schedule (Mon-Fri; Sat-Sun), adjustable settings:
Period Start Time
Occupied 1 8:00 a.m.
Unoccupied 1
10:00 p.m.
Occupied 2
Unoccupied 2
Note: Occupied 2 and Unoccupied 2 periods may be programmed as needed,
depending on installed configuration.

Setting a Schedule

To edit a schedule on the controller screen, follow
the steps below.
1 Touch Menu on the controller home screen.
2 Touch the or
SCHEDULE, then touch Select.
3 Touch the or
a day or set of days, then touch Select on the
period you want to edit.
4 Touch Yes to turn the system on for the
period.
5 Touch the time area, then touch
adjust when the period starts. Touch Select to
confirm.
6 When the temperature area starts blinking,
touch or to adjust your preferred
temperature for the mode that is currently
active (either heating or cooling). Touch Select
to confirm. Then touch
preferred temperature for the inactive mode.
Touch Select to confirm.
7 Edit the next period or use the
DONE, then press Select to save changes
and go to the home screen.
Note: Schedule menu and System ON/OFF
options are available only if enabled in the
controller Installer Setup menu.
33-00447EFS_B.indd 11
Heat (Mon-Fri)
69 °
61 °
-- --
-- --
arrows until you see
arrows to select a period in
or
or to adjust your
until you see
Cool (Mon-Fri) Heat (Sat-Sun) Cool (Sat-Sun)
79 ° 69 °
83 ° 61 °
--
--
to
Heat
Note: Images above show
settings in Residential
mode. The same
steps apply to adjust
the schedule while in
Commercial mode.
11
79 °
83 °
-- --
-- --
Heat
10/17/2019 3:22:55 PM