Parameter Menu - Lenze SMD Instructions D'installation Et De Mise En Service

4.3

Parameter menu

Code
No. Name
Password entry
C00
Setpoint and control
C01
source
Load Lenze setting
C02
Lenze 13466184 EDBSL03 v20 EN, DE, FR, IT, ES
Possible Settings
Selection
Lenze
0 0
0 Setpoint source:
0 Analog input (terminal 8; see C34)
1 Code c40
2 Analog input (terminal 8; see C34)
3 LECOM
4 Analog input (terminal 8; see C34)
5 Code c40
6 Analog input (terminal 8; see C34)
7 Code c40
8 Analog input (terminal 8; see C34)
9 Code c40
10 Analog input (terminal 8; see C34)
11 Code c40
Note
• When C01 = 1, 5, 7, 9, or 11, use c40 for speed setpoint
• When C01 = LECOM (3), write speed command to C46
0 No action/loading complete
1 Load 50 Hz Lenze settings
2 Load 60 Hz Lenze settings
3 Load OEM settings (if present)
4 Translate
WARNING!
C02 = 1...3 overwrites all settings! TRIP circuitry may be disabled! Check codes
CE1...CE3.
NOTE
If an EPM that contains data from a previous software version is installed, C02 =
4 converts the data to the current version.
Commissioning
999 Visible only when password is active
(see C94)
Control configuration:
Control = terminals
Programming = keypad
Monitoring = LECOM
Control = terminals
Programming = LECOM / keypad
Monitoring = LECOM
Control = LECOM
Programming = LECOM / keypad
Monitoring = LECOM
Control = terminals
Programming = remote keypad
Monitoring = remote keypad
Control = remote keypad
Programming = remote keypad
Monitoring = remote keypad
Control = terminals
Programming = Modbus / keypad
Monitoring = Modbus
Control = Modbus
Programming = Modbus / keypad
Monitoring = Modbus
• C02 = 1...4 only possible with
OFF or
• C02 = 2 : C11, C15 = 60 Hz
IMPORTANT
1nh
13