Technical Data; Before Starting The Equipment - EINHELL GC-CS 85 F Instructions D'origine

4. Technical data

Rated voltage: ........................ 220-240 V ~ 50 Hz
Power input: .......................... S2 20 min 85 watts
Idle speed: ..........................................5500 min
Adjustment angle: ............35° to the left and right
Grinding wheel Ø (inside): ........................ 23 mm
Grinding wheel Ø (outside): ........... max. 108 mm
Grinding wheel thickness: ....................... 3.2 mm
Protection class: ............................................ II/
Weight: .....................................................2.05 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level ..................... 63.5 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 76.5 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 61029.
Grinding
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
Anl_GC_CS_85_F_SPK7.indb 19 Anl_GC_CS_85_F_SPK7.indb 19
-1
< 2.5 m/s
2
h
2
- 19 -
GB
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Assembly (Fig. 2-9)
•
Place the guide bar for the chain (5) in the
mount (Fig. 3) and secure from underneath
with the locking screw (Fig. 4)
•
Thread the tensioning cable (Fig. 5/Item A)
into the guide bar for the chain.
•
Screw the chain locking screw (6) onto the
tensioning cable.
•
Before starting the chain sharpener, fasten
it securely to a suitable surface (e.g. a work-
bench) at a suitable place (protected against
dust, dry, well-lit) using M8 fastening screws
and washers.
•
Make sure when doing so that the mounting
plate of the chain sharpener is pushed onto
the surface as far as it will go (Fig. 7).
12.05.16 07:48 12.05.16 07:48