Wet Vacuuming; After Use; Maintenance Schedule - Nilfisk ConvertaMAX 28 Mode D'emploi

WET VACUUMING

Fit the machine with optional attachments for wet vacuuming.
1 Disconnect the squeegee hose from the Squeegee (8).
2 Attach suitable wet pick-up tools to the hose. (Available from Nilfisk-Advance).
3 Turn the Master Key Switch (20) ON, next press and hold the Vacuum Button (25) until the indicator light turns green. The vacuum motor will run
continuously until the button is pressed again to turn it OFF. NOTE: If the control repeatedly gives a full indication when the tank is not full, the automatic
shut-off feature can be disabled, have a qualified service technician perform this function.

AFTER USE

1 When finished scrubbing, depress the Scrub Off Button (31) twice, this will automatically raise, retract and stop all the machine systems (brush,
squeegee, vacuum & solution). Then drive the machine to a service area for daily maintenance and review of other needed service up keep.
2 Turn the Master Key Switch (20) OFF and remove the key.
3 To empty the solution tank, pull the Solution Drain Hose (4) off the elbow. Direct the hose to a designated "DISPOSAL SITE". Rinse the tank with clean
water. Inspect the solution hoses; replace if kinked or damaged.
4 To empty the recovery tank, take the Recovery Drain Hose (5) off its hanger. Direct the hose to a designated "DISPOSAL SITE" and remove the plug.
Rinse the tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.
5 Remove the brushes or pad holders. Rinse the brushes or pads with warm water and hang it up to dry. Allow buffing pads to dry completely before
using again.
6 Remove the squeegee, rinse it with warm water and hang it up to dry.
7 Check the maintenance schedule below and perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Check / Clean Vacuum Shut-Off Float
Check Hand Brake For Wear & Adjustment
*Have your Nilfisk-Advance Dealer check the carbon motor brushes once a year or after 300 operating hours.
8 Store the machine in a clean, dry place.
44 - FORM NO. 56041464 - ConvertaMAX
Maintenance Item
Check / Clean Tanks & Hoses
Check / Clean the Brushes/Pads
Check / Clean the Squeegee
Charge the Batteries
Check Battery Water Level
Inspect and Clean Solution Filter
Lubricate the Machine
*Service the Vacuum Motor
™ 28 / I-MAX
Daily Weekly
X
X
X
X
X
X
X
X
™ 28HD / BA 750 / BA 850
Monthly Yearly
X
X