Bosch AdvancedTableCut 52 Notice Originale page 23

sal guide can be set.
The power tool is designed with sufficient capacity for saw-
ing hardwood and softwood as well as chipboard and fibre-
board.
This power tool is not suitable for sawing aluminium or other
non-ferrous metals.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Clamping lever of the universal guide
(2) Universal guide with scale for mitre angles
(3) Saw blade
(4) Protective guard
(5) Saw table
(6) Mounting holes
(7) Transport handle
(8) Push stick storage
(9) Push stick
(10) Connecting rod
(11) Connecting rod locking mechanism
(12) Off button
(13) On button
(14) Scale for bevel angles
Rotary knob for adjusting the bevel angle
(15)
(16) Angle indicator (bevel)
(17) Wing bolt for loosening and securing the bevel
angle
(18) Accessories drawer
(19) Knurled screw for fixing the universal guide
(20) Cable holder
Additional stop for universal guide
(21)
(22) Extraction outlet
(23) Guide rail of the universal guide
(24) Crossways guide groove for the universal guide
(25) Lengthways guide groove for the universal
guide
(26) Release button for additional stop holder
(27) Additional stop wing bolts
(28) Locking lever for cover of saw blade receptacle
(29) Cover of saw blade receptacle
(30) Holder for protective guard
(31) Saw blade guide unit
(32) Drive shaft
(33) SDS saw blade receptacle
(34) Workpiece support
(35) Angle indicator (mitre)
(36) Scale for mitre angle
(37) Screw grabber for wing bolt and clamping lever
Bosch Power Tools
Technical Data
Table saw/pull-push saw
Article number
Rated power input W
-1
No-load speed min
Saw blade receptacle
Weight according to kg
EPTA-Procedure
01:2014
Protection class
Maximum workpiece dimensions (see "Maximum Workpiece Dimen-
sions", page 26)
The specifications apply to a rated voltage [U] of 230 V. These spe-
cifications may vary at different voltages and in country-specific mod-
els.
Noise Information
Noise emission values determined according to EN
62841-3-1.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 90 dB(A); sound power level
100 dB(A). Uncertainty K = 3 dB.
Wear hearing protection
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.
Items included
See the list of items included at the start of
the operating manual.
Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
English | 23
AdvancedTableCut 52
3 603 M12 0..
550
8200
SDS
8.5
/ II
1 609 92A 3LB | (08.01.2019)