Technical Features - Fermax DUOX Manuel D'installation

DUO DUO DUOX RISERS SPLITTER DUO DUO X RISERS SPLITTER X RISERS SPLITTER X RISERS SPLITTER X RISERS SPLITTER
DUO DUO X RISERS SPLITTER X RISERS SPLITTER
DUO DUOX RISERS SPLITTER DUO X RISERS SPLITTER X RISERS SPLITTER
c1)
o
c2)
o
c3)
o
d) Switch:
SW1: Switch to select the operating modes
OFF: Powering only risers mode
o
ON: Powering riser + panels mode
o

TECHNICAL FEATURES

Power Supply
Consumption only risers mode
18V
+ - PWR ON OFF SW1 PWR DATA B1 B1 B2 B2 PWR DATA
SW1: DOWNLINK POWER OUTPUT
18V 18V
B1 B2 B1 B2
DERIVADOR TRONCALES DUOX
DUOX RISERS SPLITTER in standby
REF: 3258
SW1 OFF SW1 ON
B/B B/B
18V
INPUT
B B B B PWR DATA call
Consumption risers + panels mode
in standby
call
Operating Temperature
Minimum input data signal (no ripple)
Programmer ref. 3254.
The maximum number of terminals per riser (depending on the installation topology)
If the splitter module does not include a power source, the limit of telephones is no longer dependant
on the splitter´s power capacity and is determined by the voltage drop. In the worst case
operating conditions, the last telephone connected to this riser must receive at least 15V and this
depends on the wiring and the supported load of telephones.
Up to 4 riser splitters can be concatenated in parallel and on each output a new splitter can be
inserted (maximum 2 levels).
The maximum direct current charge during the riser startup is 1A.
B, B: Green signal LED with data in the input riser
B1, B1: Green signal LED with data in the input riser 1
B2, B2: Green signal LED with data in the input riser 2
This signal can be measured via the Duox
18 Vdc
71 mA
91 mA
73 mA
93 mA
[-5º , +40ºC]
0,5 Vp
200
Page 7