Introduction; Risers Splitter Installation - Fermax DUOX Manuel D'installation

DUO DUO X RISERS SPLITTER X RISERS SPLITTER
DUOX RISERS SPLITTER DUO DUO X RISERS SPLITTER X RISERS SPLITTER
DUO DUO DUOX RISERS SPLITTER X RISERS SPLITTER X RISERS SPLITTER X RISERS SPLITTER
DUO DUO X RISERS SPLITTER

INTRODUCTION

The DUOX risers splitter is an intermediary device in a DUOX installation whose main
functions are to insulate, distribute, regenerate and power the installation´s rises.
If there is a failure in a riser or entrance, either because of a bus short circuit or a data
failure, one does not affect the other. This way it is not absolutely necessary to power
each output of each of the risers since the device is capable of powering said risers
(following the maximum charge).
This power can be received locally (without a filter) in two ways:
- a) Powering only rises mode: in this mode the power reaches each of the rises.
- b) Powering rises + panels mode: This way the power reaches each of the rises and also
the street panels (in case the street panel does not have local power).
a)
18V
SW1 OFF
B/B
18V
Notes:
- There cannot be more than 24 telephones per trunk without providing additional power.
- When a trunk shunt is installed, the telephones must be connected in this one's risers.
There may not be any telephones between the panel and shunt.
- (*) A single power source can only power 1 panel and 24 telephones per riser.

RISERS SPLITTER INSTALLATION

Installation in a DIN rail
Assembly
M A D
E
IN
S PA
IN
50 -60
Hz
. 50 VA
+1 8V MA
X.
O N
O V
E R
L O
A D
Fastened with screws
M
A D
E IN
S PA
IN
50 -60
Hz . 50
VA
+1 8V MA
X.
Page 4
B1 B2
O N
O V
E R
L O
A D
b)
18V
SW1 ON
B/B
(*)
Disassembly
M
AD
E IN
SP
AI
N
50
-60 Hz
. 50
+1 8V VA
MA X.
Note: This must be installed
on the interior, preferably
within an installations box.
B1 B2
O N
O V
E R
L O
A D