Turning Power On/Off; Turning Off The Power; Specifications - Sharp LL-S201A Manuel D'installation

Turning on the power
1. Press the POWER button.
The power LED turns on.
2. Turn on the PC.
The screen appears.
Status
Green lit
Orange lit
nOperation mode
When the monitor is turned on for the first time after being shipped from the factory, the operation mode setting screen will be
displayed. Set it to MODE1 or MODE2.
MODE1 ....If there is no operation for 4 hours or more, the monitor automatically enters standby mode. Power consumption in
standby mode is also minimized.
MODE2 ....Will perform standard operation.
Even after being set, changes can be made using [Operation mode], located in the menu of the monitor. (See OPERATION
MANUAL.)
Model
Power requirement
Operating temperature
Operating humidity
Power consumption
Dimensions (excluding protrusions)
Weight
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
8
E

Turning Power ON/Off

POWER button
Press
Power LED
Status of the monitor
Signal input
No signal input

Specifications

LL-S201A
AC 100 V - 240 V, 50/60 Hz (when using the supplied AC adapter)
32°F to 95°F (0°C to 35°C)
20% to 80% (no condensation)
35 W
inch (mm) Approx. 18-1/4 (W) x 1 (D) x 10-13/16 (H) (463.8 x 25.2 x 274.8)
lbs. (kg) Approx. 5.07 (2.3) (excluding the stand)
Approx. 6.39 (2.9) (including the stand)

Turning off the power

1. Turn off the PC.
2. Depress the POWER button for around 2 seconds.
The power LED turns off.
Caution
• If the monitor will not be used for a long time, disconnect
the power plug from the power outlet.
POWER button
Depress for around
2 seconds