Klarstein VIRTUOSA FLEX 90 Mode D'emploi page 55

Touching the heating zone selection control and an
indicator where you touched will flash.
Adjust heat setting by touching the slider control.
• If you don t choose a heat setting within 1
minute, the Induction hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any time
during cooking.
If the display flashes
• you have not placed a pan on the correct cooking zone or,
• the pan you re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The display
will automatically turn off after 1 minute if no suitable pan is placed on it.
Finish Cooking
Touching the heating zone selection control that you
wish to switch off.
Turn the cooking zone off by touching the slider to
the left. Make sure the display shows "0".
alternately with the heat setting:
EN
55