Klarstein VIRTUOSA FLEX 90 Mode D'emploi page 49

• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
After Installing the Hob
Make sure that:
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
Attaching the Fixing Screws
1. The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
2. Fix the hob on the work surface by screw 4 brackets on the bottom of hob(see picture)
after installation.
3. Adjust the bracket position to suit for different table top thickness.
Note: Under any circumstances, the brackets cannot touch with the inner surfaces of the
worktop after installation (see picture).
Hob
Bracket
Hob
Bracket
EN
49