Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 7:
1.
Connect the plug of middle section secsor wire (9) to the sensor
socket of monitor (13).
2.
Do the same for motor cable (7/13) connection.
3.
Do the same for power supply cable (79/13) connection.
4.
Slide the monitor (13) to top welded monitor bracket of front post
(12).
5.
Insert the plug of hand pulse wire (17) to hand pulse wire jack of
monitor (13).
Step 8:
1.
Attach left upper handlebar (75L) with grips (20),caps (19) to upper
handlebar tube of left swing handlebar (25L) and fix with 2 carriage
bolts (72), 2 curve washers (74),2 spring washers (77) and 2 cap
nuts (73).
2.
Do the same for right upper handlebar (75R) with right swing
handlebar (25R) connection.
Step 9
1.
Please insert the plug of adaptor (82) to the jack(80) of
chainguard.
2.
Please insert the plug of adaptor (82) to the jack of wall power.
Step 9:
Checks
1.
Check the correct installation and function of all screwed and plug
connections.
Installation is thereby complete.
2.
When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
The computer switches of automatically approx. 4 minutes after training is
stopped. All values attained until the will be deleted.
17
Publicité
Table des Matières
