Installing Accessories - Kaco Powador 39.0TL3 Mode D'emploi

30.0-40.0TL3 F=1,5kN
60.0-72.0TL3 F=1,7kN
Fig. 9: Erecting the device
1 Shackle
2 Transportation rope
Drilling the holes
1 Mark (4x) drill holes on bottom.
2 For wall mounting: Mark the position of the holes on the wall (2x) and insert the wall anchors into the wall for addi-
tional security.
3 Drill the holes. Floor: 12 mm diameter, wall: 9 mm diameter.
» Install and secure the device.
Securing the unit
1 Position the device above the drill holes.
2 Use the four anchoring bolts to secure the device to the floor.
3 For wall installations: secure the device to the wall with 2 screws.
» Installing the housing
6.5

Installing accessories

Installing the housing on the Powador 39.0-48.0TL3
Installing the hood
↻ EMC sheet metal removed
1 Place the hood on the top side of the housing.
2 Fix the hood to the housing from the inside using the enclosed fastening screws.
Removing the EMC sheet metal
1 Unscrew the 4 M4x10 screws from the EMC sheet metal.
2 Remove and store the EMC sheet metal.
Placing the EMC sheet metal on the housing
↻ Housing covers installed.
1 Place the EMC sheet metal on the housing.
2 Fix the EMC sheet metal to the housing using the 25 enclosed M4x10 screws.
» The device is installed.
Installing the side housing cover
↻ Hood installed.
1 Place the left housing cover on the device housing.
2 Fix the housing cover to the housing from the inside using the 2 enclosed M4x10 screws.
Page 16
1
2
Fig. 10: Centre of gravity of device
3
Powador 39.0TL3 , Powador 39.0 TL3 M1 , Powador 40.0 TL3 , Powador 48.0 TL3 Park , Powador 60.0 TL3 ,
3
Centre of gravity
Powador 72.0 TL3 Park