Transporting The Device; Installation Tool; Assembly And Preparation; Choosing The Installation Location - Kaco Powador 39.0TL3 Mode D'emploi

5.2

Transporting the device

CAUTION
Hazard due to impact; risk of breakage to the device!
› Pack the device securely for transport.
› Carefully transport the device using the transportation pallet.
› Do not expose the device to any shocks.
5.3

Installation tool

The codes given in the table below are used in all usage instructions for assembly/installation/maintenance and disas-
sembly for the tools and tightening torques being used.
Code (s)
W
A
T
S
Tab. 2: Key and description of tool codes
6

Assembly and preparation

6.1

Choosing the installation location

DANGER
Risk of fatal injury due to fire or explosions!
Fire caused by flammable or explosive materials in the vicinity of the device can lead to serious injuries.
› Do not mount the inverter in potentially explosive atmospheres or in the vicinity of highly flammable
materials.
CAUTION
Property damage due to gases that have an abrasive effect on surfaces when they come into contact
with ambient humidity caused by weather conditions.
The device housing can be seriously damaged due to gases in combination with air humidity resulting from
weather conditions (e.g. ammonia, sulphur).
› If the device is exposed to gases, the installation must be carried out at observable locations.
› Perform regular visual inspections.
› Immediately remove any moisture from the housing.
› Ensure adequate ventilation at the installation location.
› Immediately remove dirt, especially on vents.
› Failure to observe these warnings may lead to device damage which is not covered by the manufac-
turer warranty.
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or mounting conditions shall be billed to the cus-
tomer.
Installation space
ž As dry as possible, climate-controlled, the waste heat must be dissipated away from the device.
Powador 39.0TL3 , Powador 39.0 TL3 M1 , Powador 40.0 TL3 , Powador 48.0 TL3 Park , Powador 60.0 TL3 ,
Powador 72.0 TL3 Park
Shape of the
connector
External hexagon
Internal hexagon
Torx
Slot
Tightening torque
Spanner size or number
Outer contour
Fig. 2: Form pattern
Nm
Page 13