Possibilities For Insertion - ZANKER ZKE320 Notice D'utilisation

Masquer les pouces Voir aussi pour ZKE320:

Notice d'utilisation (36 pages)

Table des Matières

Les langues disponibles

• Make sure that the rated voltage and type of power

on the rating plate agree with the voltage and the

power of the local power supply.

• This appliance is supplied with a mains cable. It has

to be supplied with a correct plug, able to support the

load marked on the rating plate. The plug has to be

fitted in a correct socket.

• Any electrical component must be installed or re-

placed by the Service Force Centre technician or

qualified service personnel.

• Always use a correctly installed shockproof socket.

• Make sure that there is an access to the mains plug

after installation.

• Do not pull the mains cable to disconnect the appli-

ance. Always pull the mains plug.

• The appliance must not be connected with an exten-

sion cable, an adapter or a multiple connection (risk

of fire). Check that the ground connection is in con-

formity with the standard and regulations force.

• The power cable must be placed in such a way that

it does not touch any hot part.

• Connect the appliance to the mains with a device

that lets to disconnect the appliance from the mains

at all poles with a contact opening width of minimum

3 mm, eg. automatic line protecting cut-out, earth

leakage trips or fuse.

• None of a parts of the connection cable can not get a

temperature 90 °C. The blue neutral cable must be

connected to the terminal block label with "N". The

brown (or black) phase cable (fitted in the terminal

block contact marked with "L") must always be con-

nected to the live phase.

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F

T90 or equivalent type. Make sure that the cable sec-

tion is applicable to the voltage and the working tem-

perature. The yellow/green earth wire must be approxi-

mately 2 cm longer than the brown (or black) phase

wire.

Assembly

min. 650 mm

If several 30 cm hobs are to be installed side by side

into the same cut out, an assembly kit including a sup-

port side bracket and supplementary seals is available

at our Service Centres. The relevant installation instruc-

tions are supplied within the kit package.

A — seal to remove

B — supplied brackets

Caution! Install the appliance only on a worktop

with flat surface.