Adjusting Trim Angle (Power Trim And Tilt) - Yamaha F115 Manuel De L'utilisateur

Operation
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
1. Trim operating angle
EMU27889
Adjusting trim angle (Power trim and
tilt)
EWM00754
WARNING
 Be sure all people are clear of the out-
board motor when adjusting the trim an-
gle. Body parts can be crushed between
the motor and the clamp bracket when
the motor is trimmed or tilted.
 Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instability
or control problems. Improper trim an-
gle can cause loss of control.
 If equipped with a power trim and tilt
switch located on the bottom cowling,
use the switch only when the boat is at a
complete stop with the engine off. Do
not adjust the trim angle with this switch
while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
70
UP
DN
1
1. Power trim and tilt switch
1
DN
UP
1. Power trim and tilt switch
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
ZMU01781
ZMU07381