Outboard Motor; Flushing Device; Install Cowling - Yamaha F115 Manuel De L'utilisateur

4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
3 2
1. Oil dipstick
2. Upper mark
3. Lower mark
EMU40412

Outboard motor

 Check that the outboard motor is mounted
properly and check the outboard motor
mounting bolts for looseness.
 Check the propeller for damage.
 Check for engine oil leaks.
EMU36494

Flushing device

Check that the flushing device's garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling. NOTICE: If the
garden hose connector is not properly
connected, cooling water can leak out and
the engine can overheat during operation.
[ECM01802]
1. Fitting
1
2. Garden hose connector
3. Flushing device
EMU36965
ZMU08224

Install cowling

1. Be sure that all cowling lock levers are
released.
2. Be sure that the rubber seal is seated all
the way around the top cowling.
1
2
1. Top cowling
2. Rubber seal
3. Place the top cowling on the bottom
cowling.
4. Check to be sure the rubber seal is seat-
ed correctly between the top cowling
and the bottom cowling.
5. Move the cowling lock levers to lock the
top cowling as shown. NOTICE: If the
top cowling is not installed correctly,
Operation
3 2 1
ZMU08089
ZMU08090
59