Treatment Of Submerged Motor - Yamaha F115 Manuel De L'utilisateur

Trouble Recovery
6. Unscrew the filter cup, and then remove
the O-ring from the filter cup. NOTICE:
Be careful not to twist the water de-
tection switch lead when unscrewing
the filter cup.
[ECM01961]
1. O-ring
2. Filter cup
3. Water detection switch lead
7. Drain the water in the filter cup by soak-
ing it up with a rag.
8. Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing. NOTICE: Be
careful not to twist the water detec-
tion switch lead when screwing the fil-
ter cup onto the filter housing.
1. O-ring
2. Filter cup
3. Water detection switch lead
9. Fit the fuel filter into its holder, and then
fasten the hoses with the hose holder.
10. Install the cover.
104
3
ZMU08141
[ECM01971]
1
2
3
ZMU08125
11. Connect the water detection switch cou-
pler securely until a click is heard.
12. Install the top cowling.
13. Turn the main switch to the "
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
arator-alert indicator blinks or the buzzer
1
sounds, have your Yamaha dealer check
the outboard motor. NOTICE: Although
the buzzer will stop when the engine is
started and the remote control lever is
2
moved to the forward or reverse posi-
tion, do not use the outboard motor.
Otherwise, serious engine damage
could occur.
EMU33502

Treatment of submerged motor

If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
" (on) po-
[ECM02391]
[ECM00402]