Power Trim And Tilt Switch On Bottom Cowling; Power Trim And Tilt Switches (Twin Binnacle Type) - Yamaha F115 Manuel De L'utilisateur

Components
UP
DN
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch " " (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 71.
EWM01032
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
32
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
UP
ZMU01720
DN
1. Power trim and tilt switch
EMU26164
Power trim and tilt switches (twin bin-
nacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switches, see
"
pages 69 and 71.
UP
1. Power trim and tilt switch
" (down) tilts the outboard
1
DN
1
ZMU08075
" (up) trims the
ZMU04601