Fitting And Removing The Wheels; Folding And Unfolding; Pro-Fix System - JANE TRIDER Instructions

Masquer les pouces Voir aussi pour TRIDER:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

1.- FITTING AND REMOVING THE WHEELS

Before using the TRIDER pushchair for the first time it is ne-
cessary to fit the rear wheels. To fit the wheels press the but-
ton on the middle of the wheel and insert the axle into the
rear wheel bearer and push until it slots firmly into place.
If you need to remove the wheels, press the central button
and take the wheel off.
1.a
To assemble the front wheel fit the upper axle into the lower
part of the frame until it clicks into place.
If you need to detach it, press the button on the inside of the
frame and take the wheel off.

2.- FOLDING AND UNFOLDING

To unfold your TRIDER, lightly press the bar on the back to tilt
the buggy and make it easier to manoeuvre.
handlebar with one hand while you press the locking pedal
at the bottom on the right.
4
until it clicks and locks into place.
To fold your TRIDER place the hammock in the folding posi-
tion (P) (see ADJUSTING THE ANGLE OF THE SEAT).
Next, press the safety button on the left of the handlebar
while pulling both side catches
forwards until it is fully folded.
1
2
2.a
3
Then hold the
Pull the handlebar and unfold
5
6
7.a
7.b
pushing the handlebar
7.c
When folding the pushchair it is useful to place the hammock
facing forwards as this makes it fold up more compactly.
WARNING: You must make sure that the child is kept away from
the pushchair while it is being folded or unfolded. During the-
se operations the appearance of sharp points and compression
areas are inevitable.

3.- PRO-FIX SYSTEM

The chassis of your pushchair is fitted with the PRO-FIX sys-
tem, making it ready for the following baby carriers and child
Restraint Systems to be attached: MICRO, MATRIX, KOOS and
NEST.
8-9
The PRO-FIX system makes it easier to attach and remove the-
se accessories to and from the chassis, securing them to the
chassis in a quick, simple and safe way. To do this follow the
instructions for these accessories carefully.
WARNING: It is necessary to remove the hammock from the
pushchair to attach any of the auto accessories.
23

Publicité

Table des Matières
loading

Table des Matières