Initial Start-Up; Charging The Battery; Extracting Shavings/Dust; Operation - Parkside PHA 12 A1 Traduction Des Instructions D'origine

GB IE

Initial start-up

Charging the battery

If warm, allow the battery to cool
before charging.
Do not expose the battery to direct
sunlight for long periods and do not
place it on a radiator (max. 50 °C).
1. 1. Plug the charger into a socket.
2. Slide the battery (6) into the charging
slot of the charger.
3. Once charging is complete, disconnect
the charger from the mains supply.
4. Remove the battery (6) from the charger.
A detailed description of the
charging process and further
information can be found in
the separate operating ins-
tructions to your Parkside X
12 V Team series battery and
charger.

Extracting shavings/dust

You can use the cordless planer optionally
with an external shavings extractor (not
included in delivery) or with the shavings
ejector.
The shavings are ejected on both sides of the
ejection chute if neither the shavings ejector
nor an external shavings extractor are used.
Shavings ejector
Place the shavings ejector (12) into the
ejection chute (8). Make sure that the gui-
de rails on the shavings ejector (12) fi t into
the grooves of the ejection chute (8).
The shavings ejector (12) can be fi tted to
eject to the left or right.
24
Shavings extraction adapter
The shavings extraction adapter (11) can
be fi tted to eject to the left or right.
1. Place the shavings extraction adapter
(11) into the ejection chute (8).
Make sure that the part of the shavings
extraction adapter (11) that is in the
ejection chute (8) is open at the bottom.
2. Attach an external extraction system.
Make sure that the dust extraction system
is suitable for the material to be cut. This
information can be found in the opera-
ting instructions of the external device.

Operation

Setting the cutting depth

The best cutting depth for the cordless pla-
ner is between 0 and 1.0 mm.
The cutting depth can be selected by tur-
ning the controller (
The cutting depth can be set in 10 x 0.2
mm increments.
The green area of the scale below the con-
troller ( 1) indicates the setting which
removes the least amount of material.
The red area of the scale indicates the setting
which removes the most amount of material.

Switching on/off

Switching on:
1. Press one of the safety switches (4) on
the right or left of the handle.
2. Press the on/off switch (5).
3. You can now release the safety switch (4).
Switching off:
4. Release the on/off switch (5).
1).