Start-Up; Router Set / Applications; Using The Router Tool; Attaching The Extractor Adapter - Parkside POF 1200 A1 Instructions D'utilisation Et Consignes De Sécurité

Start-up / operation

Start-up

Router set / Applications

Original attachment included in delivery:
To profile:
Round and profile cutter, 24.7 mm
32
Round and profile cutter, 28.6 mm
33
Round and profile cutter 28.6 mm (R–4)
34
Hollow cutter, 12 mm
35
Hollow cutter, 24.7 mm
36
V-groove cutter, 9.5 mm
37
V-groove cutter, 16 mm
38
Bevel cutter, 32 mm
39
To connect:
Dovetail cutter, 14.3 mm
40
Flush cutter, 12.7 mm
41
Slot cutter, 6 mm
42
Slot cutter, 12 mm
43
Note: Provided the router's ball bearing has loos-
ened, tighten it with the Allen key provided in the
router set.

Using the router tool

Press and hold the spindle lock key
Release the union nut
spanner by turning it anticlockwise.
27
Release the spindle-lock key
Then use the router tool. This must be inserted
at least 20 mm (shaft length).
Tighten the union nut
ended spanner
27

Attaching the extractor adapter

Put the extractor adapter
tractor provided.
18
Screw together the extractor's screws
the under side of the base plate
Connect a vacuum device approved for the
extraction of sawdust and splinters to the ex-
tractor (see Fig. G).
21
30 GB
.
10
with the open-ended
3
.
10
firmly with the open-
3
.
on the drilling ex-
21
and
22
.
7

Reducer

Connecting:
Slide the reducer
28
Slide the hose for an approved dust extraction
unit (e.g. a workshop vacuum) onto the reduc-
er .
28
Removal:
Pull the hose of the vacuum unit off of the re-
ducer .
28
Pull off the reducer

Changing the collet

Note: All router bits of the router sets have a 8 mm
shaft.
Start with the already installed collet 8 mm
Change the collet for a router bit with a 6 mm shaft
as described below.
Release the union nut by turning it anticlock-
wise using the open-ended spanner
the collet 8 mm
4
Insert the collet 6 mm
ATTENTION! Tighten the union nut
with the open-ended spanner
er bit is inserted. otherwise the collet might
17
be damaged.

Fitting the guide fence

Unscrew the both of the sliding bar's
with a Philips screw driver.
Secure the sliding bar
and tighten the screws.

Operation

Switching on and off

Switching on:
Press and hold the start lockout
Activate the oN / oFF switch
machine has started, release the start lockout
in to the suction adapter
.
28
.
4
until
27
is removed.
.
23
firmly
3
once the rout-
27
screws
29
to the rip fence
29 24
.
20
. once the
19
.
21
.
20