Maintenance; Trouble Shooting - Num'axes CANICOM 200 Guide D'utilisation

- The repeated rubbing of the contact points against the animal's skin may cause irritation. If this
happens, remove the collar until all signs of skin irritation have disappeared.
- Keep your CANICOM 200 unit out of reach of children. It is not a toy for you or your children.

Maintenance

- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.

Trouble shooting

Should your CANICOM 200 stop working or develop a fault, first read this user's guide over, then check
the batteries (see § Checking/replacing battery of remote control and § Checking replacing battery of
receiver collar) and replace them if necessary and retry. Also check that you are using the product
correctly.
If you encounter any problems, re-initialize the receiver by re-coding it (ref. re-coding procedure).
Re-initialise the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 7).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor.
According to the extent of the malfunction, you may have to return your product for check and repair.
For all repairs, please supply the following:
- the complete product
Gb - 30
Diagram 7
Reset: connect
the 2 supports of
the battery