Changing The Contact Points; User Advice; How To Check That Your Canicom 200 Is Functioning Properly - Num'axes CANICOM 200 Guide D'utilisation

Masquer les pouces Voir aussi pour CANICOM 200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
• Battery fully charged: flashes slow green.
• Weak battery: flashes quickly red. Replace it with a new battery 3-V Lithium CR2 (See § Fitting the
battery in the receiver collar). Check the receiver collar operates correctly.

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with long contact points supplied with the kit. Carefully tighten them manually
(do not use a key).

User advice

The CANICOM receiver collar is totally waterproof. Your dog can swim in water. In order to maintain
water tightness, we recommend the replacement of seal located in the receiver collar every year.
The remote control is shower proof only: it is only designed to remain a short time in the rain. Put it safe
from water as soon as possible. If the remote control falls into the water, it could be damaged in an
irreversible way.
Remove the battery from the receiver collar and from the remote control if you are not using the
appliance for 3 months or more.
The collar will memorize the configuration chosen (coding). The next time you turn it on, CANICOM 200
will be in mode you selected last.

How to check that your CANICOM 200 is functioning properly

You can check that your CANICOM 200 is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- You can place the neon test lamp in contact with each of the contact points (by unscrewing them then
by screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the « F » or « C » button by modifying the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.
Gb - 27

Publicité

Table des Matières
loading

Table des Matières