EVBOX WALL BOX Manuel D'installation page 15

Part number: 9835663080
EN
2. Install wall dock
2.10
Place one part of the strain relief in the bottom of the wall dock.
Place the feed wire over the bottom part of the strain relief and mount the rubber seal in the
outer edge of the wall dock.
Note: Be aware that the rubber seal has three groove edges and one tongue edge. Make
sure that you place the tongue edge facing upwards.
Place the top part of the strain relief over the feed wire and use the two 4 x 40 mm screws
and the Torx T20 head to mount the strain relief on the feed wire. Do not overtighten.
2.11
Connect the wires in their designated terminals. Mount the transparent cover.
Make sure no wiring is protruding from under the transparent cover.
Make sure that the rubber seal gasket around the connectors is in place before assembling
the transparent cover.
Tighten the bolts with the T20 bit. Do not overtighten.
Fasten the special bolt in the bottom right corner with a regular flat-head screw driver. This
special bolt can be used for sealing the installation with a tamper-evident seal.
L1 L2 L3
PE N
Note: Installation example of a 1-phase connection.
16
INSTALLATION_WALL_BOX_SOCKET_PSA_B2C_MERGED.indd 16 11-9-2019 8:30:06