Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi DV 14DV Mode D'emploi

ASSEMBLY AND OPERATION

APPLICATIONS

Use as a hammer drill
Drilling of soft bricks and concrete blocks.
Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Insert
Pull out
Fig. 3

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Battery
Pilot Lamp
Fig. 4
Switch Trigger
Handle
Latch
Battery
Push
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
you or someone around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches on the sides of the
battery. (Fig. 3)
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
English
13