Selecting The Spray Setting (Gravity Spray Attachment); Selecting The Spray Setting (Wall Extra I-Spray Spray Attachment) - WAGNER W 690 FLEXIO EXTRA KIT Mode D'emploi

W 690 Flexio Extra Kit
6. Connect the front part with the rear part of the gun. (Fig. 5)
Gravity spray attachment
7. Insert the container in the gun body and secure by turning with the bayonet lock.
(Fig. 6)
8. Connect the front part with the rear part of the gun. (Fig. 5)
9. Place the gun with the pedestal folded out on an even surface.
Only fill the container once it is attached to the gun, since otherwise the
i
coating material will leak out.
10. Pour the prepared coating material into the container.
11. Close the container with the cover.
12. Attach the valve hoses to the container cover and gun body. (Fig. 7)
The enclosed practice poster is ideal for familiarising yourself with
i
operation of the spray gun. After trying out the first spray coatings, it
makes sense to test it further on cardboard or a similar surface in order
to find out the right flow rate of paint and air for the best spray pattern.
Detailed information about these settings can be found in chapter
9- 13.
9. Selecting the Spray Setting (Gravity spray
attachment)
WARNING!
With the union nut (fig. 8, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 9 A = vertical flat jet
Fig. 7 B = horizontal flat jet
Fig. 7 C = circular jet
10. Selecting the Spray Setting
(Wall Extra I-Spray spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the air cap (fig. 10, 1)
Danger of injury! Never pull the trigger guard while adjusting
the air cap.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach surfaces
GB
25