Spray Technique; Taking Out Of Operation And Cleaning - WAGNER W 690 FLEXIO EXTRA KIT Mode D'emploi

W 690 Flexio Extra Kit

14. Spray Technique

The spray result depends heavily on the smoothness and cleanliness of the
i
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
Important: Start at the edge of the area to be sprayed. Start the spray
i
movement first of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm
(approx. one stirring rod in length).
Fig. 15 A/ 15 B: CORRECT Even distance to the object.
Fig. 15 B: INCORRECT An uneven distance will result in uneven paint
application.
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 16).
Interior wall paint in strong colour shades should be applied at least twice
i
(allow first paint coat to dry first). This will ensure good coverage.

15. Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning. When
processing 2-component varnishes, clean the device immediately.
1) Turn the machine off. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 5 ) slightly downwards. Turn the gun front
part and gun rear part against each other and take them apart.
GB
27