Selecting The Spray Setting (Fig. 6); Adjusting The Material Volume (Fig. 8); Spray Technique - WAGNER WallPerfect W 615 I-Spray Mode D'emploi

GB
•
Place the container on a paper base and pour in the prepared coating substance with
the aid of the feed hopper included in the scope of supply (Fig. 1, 18).
Screw the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Press the ON/OFF switch at the device.

12. Selecting the Spray Setting (Fig. 6)

WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 6, 1)
Fig. 7 A = vertical flat jet
Fig. 7 B = horizontal flat jet 

13. Adjusting the Material Volume (Fig. 8)

Set the material volume by turning the regulator on the trigger guard of the spray gun
- turn to the left
+ turn to the right
An average flow setting provides the best result for most wall paints.
i

14. Spray Technique

•
Cover all surfaces not to be sprayed.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Start at the edge of the area to be sprayed. Start the spray movement
first of all, and then press the trigger. Avoid interruptions within the area
to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 20-30 cm, depending on the desired
spray jet width.
24
for horizontal surfaces

for vertical surfaces
lower material volume

higher material volume

WallPerfect W 615 I-Spray