WAGNER WallPerfect W 615 I-Spray Mode D'emploi page 39

WallPerfect W 615 I-Spray
The guarantee runs for two years, counting from the date of sale (sales slip). It covers and
is restricted to free-of-charge rectification of faults which are demonstrably attributable
to the use of faulty materials in manufacture, or assembly errors; or free-of-charge
replacement of the defective parts. The guarantee does not cover incorrect use or
commissioning or fitting or repair work which is not stated in our operating instructions.
Wearing parts are also excluded from the guarantee. The guarantee excludes commercial
use. We expressly reserve the right to fulfil the guarantee. The guarantee expires if
the tool is opened up by persons other than WAGNER service personnel. Transport
damage, maintenance work and loss and damage due to faulty maintenance work
are not covered by the guarantee. Under any guarantee claim, there must be proof
of purchase of the tool through submission of the original receipt. Wherever legally
possible, we exclude all liability for injury, damage or consequential loss, especially if the
tool has been used for a purpose other than that stated in the operating instructions,
commissioned or repaired other than in accordance with our operating instructions
or if repairs are performed by someone who is unqualified. We reserve the right to
perform any repairs in excess of those stated in our operating instructions. In case of
guarantee or repair, please refer to your point of sale.
If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed by
the manufacturer, because special purpose tools are
required.
Warning: Do not connect the blue or brown wire to the
earth terminal of the plug! The wires in this mains lead
are coloured in accordance with the following code:
blue = neutral brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifiying the terminals in your plug,
proceed as follows:
Should the moulded plug have to be replaced, never
re-use the defective plug or attempt to plug it into a different 13 A socket. This could result in an
electric shock.
 Should it be necessary to exchange the fuse in the plug only use fuses approved by ASTA in accordance with
BS 1362. 5 Amp fuses may be used.
 To ensure that the fuse and fuse carrier are correctly mounted please observe the provided
markings or colour coding in the plug.
After changing the fuse, always make sure that the fuse carrier is correctly inserted. With out the
fuse carrier, it is not permissible to use the plug.
 The correct fuses and fuse carriers are available from your local electrical supplies stockist.
2 years guarantee
Warning
GB
31