Rectification Of Display Problems; Rectification Of Printer Problems; Fault Messages; Disposal - Bosch BAT 171 Consignes D'utilisation

6.5

Rectification of display problems

Fault message
Display is not activated with
connection to
12 V battery
Display is not activated
with no connection to 12 V
battery
6.6

Rectification of printer problems

Fault message
PRINTER OUT OF PAPER
REPLACE WITH THERMAL
PRINTER PAPER..
1.875 IN. DIA. MAX.
2.25 IN. WIDE MAX.
BATTERY VOLTAGE OUT
OF RANGE FOR
PRINTING. USE FULLY
CHARGED 12V BATTERY.
11.50 TO 16.00V
PRINTER DOOR OPEN.
CLOSE DOOR AND TRY
TO PRINT AGAIN.
6.7

Fault messages

Fault message
NO 12-VOLT
SYSTEM DETECTED.
LOW INTERNAL BATTERIES!
REPLACE BATTERIES
SOON!"
6.8

Disposal

This BAT 171 is subject to European guideli-
nes 2002/�6/EG (WEEE).
Old electrical and electronic devices,
includingcables and accessories or batteries
must be
disposed of separate to household waste.
¶
Please use the return and collection
systems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of BAT 171.
Robert Bosch GmbH
Possible cause
1. No connection to 12 V battery
2. Voltage of 12 V battery below 6 V
3. Internal batteries not fitted or flat.
4. BAT 171 defective
1. Internal batteries not fitted or flat.
2. BAT 171 defective
Possible cause
R No printer paper or not properly
inserted
R Printer paper sensor contaminated
R Printer defective
R Voltage of 12 V battery to
be tested too low.
R Contact problem
R Printer defective
R Cover open or release lever not
engaged
R Printer defective
Possible cause
BAT 171 not connected to a 12 V
battery or contact problem.
Internal batteries weak and in need
of replacement.
Maintenance | BAT 171 | 21
Remedy
1. Check the connection to the vehicle battery.
2. Fully charge the battery and repeat the battery test.
3. Check the internal batteries.
4. Inform customer service.
1. Connect the BAT 171 by way of battery clips to a 12 V battery.
2. Inform customer service.
Remedy
R Ensure proper insertion of the printer paper or fit a new roll
of printer paper.
R Make sure the printer paper sensor is clean and intact (refer
to Section 3.6)
R The printer only works if the BAT 171 is connected
to a vehicle battery with at least 11,5 V.
R Connect a vehicle battery with sufficient voltage.
R Make sure the battery clips are properly connected:
Red clip to positive post (+)
Black clip to negative post (–)
R The battery clips must make contact with the connections
on both sides.
R Close and engage the cover of the printer paper
compartment.
R Printing starts automatically.
Remedy
R Connect a vehicle battery with sufficient voltage.
R Check connection:
Red clip to positive post (+)
Black clip to negative post (–)
R The clips must make contact with the connections
on both sides.
R Replace internal batteries
BAT 171 | 21 | 21 en
|
1 689 989 061 2009-10-16