Siemens milltronics RBSS Manuel D'utilisation page 3

Introduction
Note:
• The RBSS is to be used only in the manner outlined in this instruction manual.
• This product is intended for use in industrial areas. Operation of this equipment
in a residential area may cause interference to several frequency based
communications.
The Milltronics RBSS is a high-resolution, wheel-driven return belt speed sensor that
provides speed input to an integrator when used on a belt scale system.
The RBSS has a toothed gear, wheel, and trailing arm assembly, that rides along the
return belt. The gear and wheel rotate on a shaft fixed to the trailing arm. The internal
magnetic sensor detects the gear rotation and generates a signal proportional to the belt
speed. The output signal is transmitted via cable connection to the integrator to
determine the rate of the conveyed material.
The RBSS IS speed sensor contains a Pepperl + Fuchs, NAMUR rated, inductive proximity
switch, model number: NJ0.8-5GM-N. The proximity switch detects the gear rotation, and
transmits a signal to the integrator via the associated Switch Isolator.
The Manual
This instruction manual covers the installation, operation and maintenance of the RBSS
Speed Sensor Integrator. Belt scale instruction manuals can be downloaded from our
web site at www.siemens.com/processautomation. Go to:
https://pia.khe.siemens.com/index.asp?Nr=9881.
We always welcome questions, comments, or suggestions about manual content, design,
and accessibility. Please direct your questions or comments to
techpubs.smpi@siemens.com.
7ML19985GX63 RBSS Speed Sensor – INSTRUCTION MANUAL Page EN-1