Ribimex Ribiland PRBVB2800 Manuel D'instructions Et D'utilisation page 18

3.3.2- During use
- Always direct the cable to the rear away from the appliance. Make sure the power cord is kept
behind and away from the device while you work.
- If the power cord or extension cord becomes damaged during use, disconnect the supply cord from
the mains immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY CORD FROM ITS POWER SOURCE.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
- Do not carry the appliance by the cable. Never use the power cord as a handle to lift or carry the
device.
- Always disconnect the product from the mains supply in the following circumstances:
. whenever you leave the machines; when the machine is not in use, is being carried/transported,
or is left unattended.
. before clearing a blockage; while examining, cleaning or unclogging the product.
. before checking, cleaning or working on the product, performing maintenance on it, or
attaching accessories to it.
. If the cutting device strikes a foreign object (e.g. small stone, piece of metal...) or starts to
vibrate abnormally.
- Use the machine in daylight or with adequate illumination (good artificial light).
- Do not overreach. Keep proper footing and balance at all times.
- Bear in mind that the force generated by an electrical device can make you lose your balance.
Therefore, make sure that your feet are firmly planted and that your body is well balanced when you
are operating the product.
- Never operate the machine on damp areas or wet grass.
- Do NOT use the machine on slope areas.
- Keep the chute outlet and ventilation holes (cooling air inlets) unobstructed, clear of debris and
clean at all times.
- Do not assume of your knowledge of the machine. Remember that a split second of negligence is
sufficient to cause serious damage. Be aware of your surroundings and stay alert for potential hazards
that you may not hear while operating the product.
- Keep a safe distance from the ejection zone when working with the tool.
- Be especially careful that material contains no metal parts, stones, bottles, cans or other foreign
objects before inserting into the tool.
- If the cutting mechanism strikes a foreign object or the tool starts to make strange noises or vibrate,
immediately stop tool so as to stop the cutting device.
3.3.3- Before maintenance and storage
- Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condition.
- Check the debris collection box frequently for signs of wear and/or deterioration.
- Replace any worn or damaged parts.
- Make sure to use only genuine/original replacement parts and accessories.
- For reasons of safety, any worn or damaged component should be replaced or repaired immediately
by a qualified technician.
- When not in use, store the machine only in a dry place that is inaccessible to children.
3.3.4- Before starting the product
- Only operate the product after completely assembling it.
Do NOT operate product if it is not fully and properly assembled!
- Before each use, check the machine for any signs of damage.
- Prior to each use, check the power cord for signs of damage. Under no circumstances should the
power cord be used if it shows any signs of damage.
- Ensure that the machine is only connected to conventional sockets with a 230-240V alternating
Page 18 / 35