Ribimex Ribiland PRBVB2800 Manuel D'instructions Et D'utilisation page 17

12. Operate the product only in outdoors or in well ventilated areas.
13. Do not operate the product on slopes or any other unstable location.
14.1. Become familiar with the controls and the proper use of the equipment.
14.2. Store idle machine. When not in use, product should be stored in a dry, locked up place, out
of reach of children.
14.3. Do not force the tool.
It will do the job better and safer at the rate speed for which it is intended.
The product will do a better and safer job if it is used only for the purposes it was designed for.
14.4. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are removed from the
machine before operating it.
14.5. Defective switches or other part that is damaged should be properly repaired or replaced by
an authorized service centre. Do not use the machine if the switch does not turn it on and off.
14.6. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user or operator is solely responsible for accidents or hazards or any damages or injury
caused to properties and/or persons and/or animals.
The user/operator is responsible for the safety of third persons present or entering the work area.
14.7. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
3.3- Safety precautions
3.3.1- Initial preparation before operation
- When you operate the machine, always wear full-length trousers, as well as sturdy, closed footwear
that provide good support. Do NOT operate the machine wearing shorts, when barefoot or wearing
open sandals!
- Do not wear loose clothing or jewellery that can be drawn into the inlet. Keep long hair away from
the inlet.
Under no circumstances should jewellery, any other body ornamentation, or loose clothing be worn
while operating the tool as these items could be drawn into the suction orifice.
When working outdoors, rubber gloves and non-slip footwear should always be worn.
If you have long hair, put it in a hair net.
- Wear protective equipment and always wear protective goggles while operating the tool.
Wearing protective equipment such as a dust mask, non-slip footwear, protective gloves, a helmet
and/or hearing protection (depending on the type and application of the electrical device concerned)
reduces the risk of injury.
- When performing work that generates dust, wear a dust protective mask to prevent dust irritation.
- Each time before you use the machine, check the integrity of the product's power cord and your own
extension cord for signs of damage and ageing. Do not use the machine if the cord is damaged or
worn. The product should only be operated when its accessories are in perfect working order.
Any damaged or defective components should be repaired immediately by a qualified technician.
Never attempt to use an incomplete, not fully assembled or modified machine.
- Under no circumstances should the machine be operated while safety devices, protections, defective
guards or shields are damaged or if safety equipment such as collection box is not installed.
- Only use a weather proof extension cable fitted with coupler to IEC 60320-2-3.
Only extension cords that are rated for outdoor use should be used outdoors.
2
Any extension cord used should have a minimum cross section of 1.5mm . All plug-in connections
should have an earth contact and water-spray shielding.
Page 17 / 35